Emerson Rosemount CT4400, Справочное руководство

Страница: 41 / 106

5 Verifying gas concentrations
5.1 Verification
Verification flows the known gas concentration through the analyzer and gives you a
display of the measurement, the cylinder value, and the difference between the two. You
can use verification to confirm that the analyzer is within tolerance. If it is out of tolerance,
perform a calibration (see
Calibration ).
5.1.1 Zero verification
Zero verification confirms that when no sample gas is flowing through the analyzer, the
gas concentrations measured by the analyzer are zero. To zero verify, compare the
analyzer measurements to a known sample gas using the following procedure:
Procedure
1. Use nitrogen gas of instrument gas purity as the zero verification gas.
2. Ensure that a pressure regulator is connected to the nitrogen gas bottle.
3. Connect a hose from the nitrogen gas bottle through a T-piece to the sample supply
port on the rear of the analyzer.
4. Connect an excess flow line to the unused port on the T-piece and route the excess
flow line to a suitable extractor.
5. To ensure an accurate zero measurement, the analyzer must have been switched
on for a minimum of 30 minutes prior to verifying the reading.
6. On the display controller of the analyzer select the Main Menu screen.
7. Scroll or and select GAS SERVICE . Press .
Figure 5-1: Gas Service
Reference Manual Verifying gas concentrations
00809-0100-4244 January 2020
Reference Manual 41