Emerson Daniel Senior Orifice Fitting Series, Руководство владельца и оператора

Страница: 24 / 138

10 Daniel Senior Orifice Fitting sizes 2”-8” 150-900
Section 1: Introduction Owner and operator manual
January 2015
3-9008-001 Rev M
Notes:Table 1-1
1. All Daniel Senior Orifice Fittings are supplied with pipe plugs on one side only. If
additional quantities are required, please contact the factory directly.
2. Locations of Equalizer Valve (1), Bleeder Valve (10B), and Grease Gun (23) may differ
from diagrams shown in this manual.
3. Slide Valve Lubricant: 0.38in (9.53mm) diameter by 1.5in (38.1mm) long is equivalent
to some lubricant manufacturers’ “B” size stick. The quantity of lubricant a fitting
described in this manual will require is dependent upon the state and condition of the
fitting. Daniel recommends having one box of lubricant sticks (24 sticks per box) on-
hand when performing maintenance and plate inspection/change procedures.
* Indicates Interchangeable parts for all line sizes of specified pressure rating(s).
General notes:
– Most parts available in other materials upon customer request.
– CS (Carbon Steel), CRS (Cold Rolled Steel), NPT (National Pipe Thread), ZP (Zinc Plated).
– The materials listed above indicate standard “A” trim. Various part materials are
changed for “NACE” & “AASG” trim fittings.
– Suffix “SS” added to an item number indicates a “Soft Seat” version. (Refer to Table 5-7
in Section 5: Supplemental information for item numbers and part descriptions)
– NACE MR0175 compliant trims are available upon customer request.
– Other trim options available upon request. Consult factory.
– Shaded part numbers are for items which are fluid media PIC (parts in contact).
When ordering parts, please specify:
• Catalog number
• Size
• Serial number and date of the original purchase
• Part number
• Material