SBC session border controllers
169
Syntax
lldp lldpdu [mode]
no lldp lldpdu
Parameters
<mode> — LLDP packets processing mode:
filtering — LLDP packets are filtered if LLDP is disabled on the switch;
flooding — LLDP packets are transmitted if LLDP is disabled on the switch.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> lldp lldpdu flooding
show lldp configuration
This command allows viewing the LLDP configuration of all physical interfaces of the device or specified interfaces.
Syntax
show lldp configuration [<interface>< number >]
Parameters
Optional parameters, if you omit them, the display will show information for all ports.
[interface] — interface type:
front-port — external uplink interfaces;
port-channel — external LAG uplink interface aggregation groups.
[number] — port number (you can specify several ports separated by commas «,» or you can specify the
range of ports with «-»).
for front port: <unit/port>, where:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 3];
for port-channel: [0 .. 4].
Default value
The display will show information for all ports.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> show lldp configuration
LLDP configuration
~~~~~~~~~~~~~~~~~~
Interface Status Timer (sec) Hold multiplier Reinit delay (sec) Tx delay (sec)
------------- ----------------- ------ ---------- ------------- ----------
front-port 1/0 transmit-receive 30 4 2 2
front-port 1/1 transmit-receive 30 4 2 2
front-port 1/2 transmit-receive 30 4 2 2
front-port 1/3 transmit-receive 30 4 2 2
