168
SBC session border controllers
lldp timer
This command specifies how frequently the device will send LLDP information updates.
The use of a negative form (no) of the command sets the default value.
Syntax
lldp timer <timer>
no lldp timer
Parameters
<timer> — time, may take values [5..32768] seconds.
Default value
The default value is 30 seconds.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> lldp timer 60
lldp tx-delay
This commans specifies the delay between the subsequent LLDP packet transmissions caused by the changes of
values or status in the local LLDP MIB database.
It is recommended that this delay be less than 0.25* LLDP-Timer.
The use of a negative form (no) of the command sets the default value.
Syntax
lldp tx-delay <txdelay>
no lldp tx-delay
Parameters
<txdelay> – time, may take values [1..8192] seconds.
Default value
The default value is 2 seconds.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> lldp tx-delay 3
lldp lldpdu
This command sets the LLDP packet processing mode when LLDP is disabled.
The use of a negative form (no) of the command sets the default value (filtering).
