SBC session border controllers
179
Board: <SBC-1000>v2 board, AMCC PPC460GT Glacier based, 2*PCIe, Rev. FF
I2C: ready
DRAM: 512 MB
SDRAM test phase 1:
SDRAM test phase 2:
SDRAM test passed. Ok!
FLASH: 64 MB
NAND: 128 MiB
DTT: 1 FAILED INIT
Net: ppc_4xx_eth0, ppc_4xx_eth1
Type run flash_nfs to mount root filesystem over NFS
Autobooting in 3 seconds, press 'stop' for stop
=>
7.
Enter
set ipaddr
<device ip address> <ENTER>;
Example:
set ipaddr 192.168.2.2
8.
Enter
set netmask
<device network mask> <ENTER>;
Example:
set netmask 255.255.255.0
9.
Enter
set serverip
<IP address of a computer, that runs TFTP server><ENTER>;
Example:
set serverip 192.168.2.5
10.
For SBC-1000, enter
mii si
<ENTER> to activate the network interface:
=> mii si
Init switch 0: ..Ok!
Init switch 1: ..Ok!
Init phy 1: ..Ok!
Init phy 2: ..Ok!
=>
11.
Update the Linux kernel using
run flash_kern
command
:
For SBC-2000:
SMG2016>> run flash_kern
…
TFTP from server 192.168.2.5; our IP address is 192.168.2.2
Filename ' smg2016/smg2016_kernel'.
Loading: #################################################################
###################################
done
…
Copy to Flash... done
SMG2016>>
For SBC-1000:
=> run flash_kern
About preceeding transfer (eth0):
- Sent packet number 0
- Received packet number 0
- Handled packet number 0
ENET Speed is 1000 Mbps - FULL duplex connection (EMAC0)
Using ppc_4xx_eth0 device
TFTP from server 192.168.2.5; our IP address is 192.168.2.2
Filename ' smg/smg1016M_kernel'.
Load address: 0x400000
