170
SBC session border controllers
show lldp neighbor
This command allows viewing information on the neighbour devices on which LLDP is enabled.
Syntax
show lldp neighbor [<interface>< number >]
Parameters
Optional parameters, if you omit them, the display will show information for all ports.
[interface] — interface type:
front-port — external uplink interfaces;
port-channel — external LAG uplink interface aggregation groups.
[number] — port number (you can specify several ports separated by commas «,» or you can specify the
range of ports with «-»).
for front port: <unit/port>, where:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 3];
for port-channel: [0 .. 4].
Default value
The display will show information for all ports.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> show lldp neighbor
LLDP neighbors
~~~~~~~~~~~~~~
Interface Device ID Port ID TTL
---------------- ---------------------- ----------------------- ----------
front-port 1/1 02:00:2a:00:07:15 g15 115/120
front-port 1/2 02:00:04:88:7e: front-port 1/3 105/120
SBC2000-[CONFIG]-[SWITCH]>
show lldp local
This command allows viewing the LLDP information announced by this port.
Syntax
show lldp local [<interface>< number >]
Parameters
Optional parameters, if you omit them, the display will show information for all ports.
[interface] — interface type:
front-port — external uplink interfaces;
port-channel — external LAG uplink interface aggregation groups.
