32
SBC session border controllers
4.
Open the casing of the device (more information in Sec-
tion 2.11.5).
5.
If the mounting sleeve (see Figure 24) is missing from
the device board, use the removable stand:
a.
mount the SSD onto the fixing stand;
b.
Remove the top protective layer from the ad-
hesive surface of the fixing stand;
6.
Install the drive into a vacant slot (2 slots are available
in total — see Figure 24), and if the mounting sleeve is
present on the board, fasten the drive with a screw as
shown in Figure 25.
For the SSD removal, repeat all mentioned steps in the reverse order.
SATA drive installation for SBC-2000 and SBC-3000
SATA drives may be additionally included in the device delivery package. A drive slot is designed to
accomodate 2.5'' for factor drives up to 12.5 mm thick.
Installation of SATA drives:
1.
Remove the cradle from the device housing (Figure 6, Element 1). To do this, press the button on the right
until the ejector knob is released, pull the knob to remove the cradle from the housing.
2.
Remove the mounting kit located under the ejector knob, Figure 26.
3.
Secure the drive in the cradle tray, Figure 27.
4.
Insert the cradle with the SATA drive installed back into slot and push the ejector knob until it fits with a
click.
For the SATA drive removal, repeat all mentioned steps in the reverse order.
You may also install and/or remove SATA drives when the device in energized.
Figure 26 — Mounting kit location on delivery
Figure 27 — Mounting SATA drive into cradle tray
