Elite Greenhouses KENSINGTON 10 x 6, Руководство пользователя

Страница: 14 / 40

1. The initial construction of
this gable is identical to the right
hand gable except for the changes
listed below. Door end does not
consist of louvre or shelf. The dia-
gram below shows the bolt config-
uration for the door end (Again a Dot indicates a bolt)
N.B. If your door is on the front, see the bolt configuration drawing below.
On the door end there are 3 short bracing angles to be fitted. These can be found in the main box
marked DOOR END.
2.
These three bars are identical and like the horizontal bracing angle, can be fixed either
upwards or downwards (for aesthetic reasons we suggest that you attach it the same way as
horizontal bracing angle). Using the previously inserted bolts, attach the short bracing angle to the
unit as shown (exact distances are not required). Put nuts back on and finger tip tighten all three
bars.
3. The door track support (taped together with components marked DOOR) looks similar to a ‘Z’
bar (see component diagram at beginning of booklet). The door track support is fitted on to the
middle two glazing bars utilising the two remaining unoccupied nuts and bolts. This bar is to be
fitted approx 3” below the horizontal bracing angle. The end slotted holes must face upward like a
letter ‘U’ (see diagram).
4. Tighten all nuts remembering not to over tighten. The door track support may need altering
slightly in the construction, so finger tip tight will be sufficient at this stage.
Procedure
N.B. Do not fit the door track at this stage—this will be done later in general assembly