Eliet Prof 5, Руководство пользователя

Страница: 54 / 61

54
English
14. Prof 5 PTO
Safety precautions
• Protective plate : behind the Prof 5 4S PTO, there is a protective
plate that ensures that the operator cannot reach the blades with his
hands if the machine is connected to the tractor.
Connecting propeller shaft
• Make sure that the turbine is completely free of clippings and that the blade axle can turn
without obstruction.
• Ensure that the protective plate of the Prof 5 is closed and clicked shut. If the protective plate
is not secured, the propeller shaft cannot be secured to the Prof 5.
• Connect the tractor to the Prof 5’s 3-point connector. The machine can
only be used if all three points are secure.
• Use the upper connection of the 3-point connector to adjust so that the
Prof 5 hangs flat.
• The white ring on the propeller shaft’s connection slides back. Until the
propeller shaft has been clicked into place, it has not been connected
properly.
• If the Prof 5 is connected to a tractor with a capacity greater than 13hp,
use a propeller shaft with a slip coupling. ELIET is not responsible for
damage to the machine as a result of using a tractor with an excessive
output capacity.
Using the machine
• The Prof 5 PTO runs at a PTO speed of 540 rpm. Eliet is not responsible for damage to the
machine if excessive PTO speed is used.
• Set your tractor’s accelerator so that the revolutions are 540 RPM.
• Set de machine flat on the ground before starting. The Prof 5 may not be used in transport
mode.
• Direct the blow chute to the desired position before beginning to cut. Do this by dismantling
the blow chute (see Annex B2) and then installing in the desired position.
• If you hear a strange noise, when there is a blockage or during other unforeseen
circumstances, the propeller shaft must be switched off immediately.