Eliet Prof 5, Руководство пользователя

Страница: 44 / 61

44
(F) (B)
English
11.4.3.2 To replace a shredding blade, proceed as follows:
• New RESIST/10
TM
sets are available form your ELIET Dealer under the following Art. n° BU 401
300 202
• Disassemble all bolts (M10) that secure the blades. Always use two ring spanners with long
handles to unscrew these bolt attachments. (A/F 17)
• Do not pull away the blades using your hands but use a self-grip wrench.
• It is useful to put a wedge (screwdriver) in-between the blade disks to ensure it is easy to
release them.
• First remove any dirt between the blade plates before you insert a new blade. To do so, use a
stripping blade.
• Use the same procedure as for reversing the blades:
Group 1: Check that the rear of each blade faces towards the wall (B) of the shredding chamber.
Group 2: Each blade that is mounted on a fluted part of a blade disk must face the axis line of
the blade shaft with its front side (F) .
• On replacing shredding blades, always fit new bolts and nuts.
• When refitting the shredding blades check that all bolts are tight (torque loading: 25 Nm)
• When refitting the bolts in the discs, always make sure the nut is located on the left side of the disc.
As a reminder: “All nuts in the blade shaft must always be positioned along the side of the pulley”
• After reversing or replacing the blades, always check the torque of the blade bolts after the
first 5 working hours and adjust, if required.
Caution:
• Incorrectly or poorly installed blades may lead to the machine breaking down
or being damaged. This will also put operators and bystanders in danger.
• Not retightening the blades after the first 5 working hours after reversing or
changing the blades may lead to the machine breaking down or being dam-
aged.
• The damage and consequential damage that may arise from poor maintenance
of the blades will invalidate the warranty.