9
2.1.3.11 Mobility
This function is design to avoid an accident
happening (e.g. swoon or lost consciousness)
to the user without anyone notices. Under all
modes except Away arm mode, when the
system does not detect any user movement
within the pre-set mobility period, an inactivity
(alarm) report will be sent to the monitoring
center. The display will show Alarm! Alarm! and
the siren will sound.
Options available are
Disable
(no mobility
detecting),
4 hours
,
8 hours and 12
hours.
o D i s a b l e
4 H o u r s
8 H o u r s
1 2 H o u r s
Disable
is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
The mobility time re-calcutelates once one
of the following actions occurrs:
In
Home
mode: whenever any key of
Control Panel is pressed, or whenever
any
Home Omit
DC or IR is triggered
within the pre-set Mobility time period.
In
Alarm off
mode: whenever any of
the DC or IR (except
24 Hr, Fire,
Medical Emergency and Water
) is
triggered, or whenever any keys of the
Control Panel / RC / KP is pressed
within the pre-set Mobility time period.
The
mobility
function
is
disabled
automatically when the system is set to
Away Arm
.
IR Camera (CTC-852) doesn
’t support the
Mobility funciton.
2.1.3.12 Local Siren
This is used to program whether the Control
Panel raises local alarm while sensor is
triggered.
o O n
O f f
On (Local Siren On)
is set as factory
default. When the Control Panel receives
an effectual triggered signal, its siren
raises alarm.
Off (Local Siren Off)
means when the
Control Panel receives an effectual
triggered signal, its siren will not raise
alarm.
<
<
N
N
O
O
T
T
E
E
>
>
Whe Local Siren is set is OFF, the Bell Box
(BX) and Indoor Siren (SR) are not
affected and will emit an alarm sound.
2.1.3.13 Interference
This is for you to decide whether the Control
Panel should detect signal jamming or not.
D e t e c t i o n O n
o D e t e c t i o n O f f
Detection Off
is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
When the
Detection On
is selected,
whenever the signal jamming period
lasted longer than 30 seconds, this
fault event will be logged, reported to
the Central Monitoring Station and
displayed on the LCD to warn the user.
When the
Dectection Off
is selected,
Control
Panel
will
not
check
interference status.
2.1.3.14 Tamper Alarm
This is for you to choose whether the siren
should sound alarm when the tamper is
triggered.
O A w a y A r m O n l y
N o r m a l V
Away Arm Only
is set as factory default.
Away Arm Only
means, when tamper
is triggered under Away arm mode,
Control Panel raises a local alarm and
sends report to the monitoring center.
While under others modes (Home/
Alarm off modes, etc.), the siren does
not sound nor any report will be sent,
Normal
means, Control Panel raises
a local alarm
for tamper-trigger in all
mode.
Either
Away arm only
or
normal
is