Gateway configuration manual
Profinet Slave/KNX TP – EK-BN1-TP
Revision 1.0.2 - Update: 10/12/2018
Configuration manual
© EKINEX S.p.A. – All rights reserved
Page 21
If the sequence is successful, this means that firmware and/or configuration has been correctly downloaded
on the device.
Figure 14 - Update in progress
Sequence to follow in case of known IP address:
•
Power on the device with PC and device connected by means of an Ethernet cable
•
Provide the device IP address (see Figure 12 – Update configuration form). Make sure that the PC’s
network parameters are consistent with the IP address assigned to the device
.
Otherwise, change the
PC’s network settings
•
Press
Ping
button; if you correctly applied the procedure, the text “
Device found!
” will appear (see Figure
12 – Update configuration form)
•
Press
Next
button (see Figure 12 – Update configuration form)
•
Select the desired options (see Figure 13 – Download options form): firmware update, configuration
update or both
•
Press
Execute update firmware
button
•
When all operations are completed (see Figure 14 – Update in progress) the device automatically
switches back to Normal mode.
If the sequence is successful, this means that firmware and/or configuration has been correctly downloaded
on the device.
It is recommended to update the firmware when a new version of the application program
is installed or when configuring the device for the first time.
In case the update procedure goes into PROTECTION mode (see Figure 15 – Update error, “Protection”
mode), you may want to check the following:
Figure 15 – Update error, “Protection” mode
i