Ekinex EK-BN1-TP, Руководство по настройке

Страница: 7 / 23

Gateway configuration manual
Profinet Slave/KNX TP – EK-BN1-TP
Revision 1.0.2 - Update: 10/12/2018 Configuration manual
© EKINEX S.p.A. – All rights reserved Page 7
Command elements
•
Pushbutton that switches between normal mode and KNX physical address programming.
1-way microswitches
• A - OFF: normal mode active. ON: Boot mode active
Display elements
The device can run according to two operating modes: Normal mode (configuration loaded, Profinet and
KNX communication running) and Boot mode (no configuration or still loading configuration).
LED Normal mode Boot mode
Green LED (8) – Device status Slow blinking (~1 Hz)
ON : device on
OFF : device off
Yellow LED (9) – Profinet communication
Blinks when a frame is received on the
Ethernet port
Fast blinking
: no configuration
Very slow blinking (~0,5 Hz) : loading
configuration.
Yellow LED (10) – KNX communication Blinks when a frame is received.
Fast blinking : no configuration
Very slow blinking (~0,5 Hz)
: loading
configuration.
Yellow LED (11) – Device error
ON : at least one Profinet request did not
get a correct answer
OFF : no error
Fast blinking : no configuration
Very slow blinking (~0,5 Hz) : loading
configuration.
Green LED (7) – Ethernet port
ON : Ethernet connector plugged
OFF : Ethernet connector unplugged
ON : Ethernet connector plugged
OFF : Ethernet connector unplugged
Red LED (3) – KNX programming
ON : physical address programming mode
on
OFF
: physical address programming mode
off
Fast blinking : no configuration
Very slow blinking (~0,5 Hz)
: loading
configuration.
In the current version of the device, both KNX physical address programming and
configuration download must be performed through the configuration program: for KNX
physical address please refer to “Communication parameters” paragraph, “ID Device”
parameter.
i