9 | Attaching/Removing the Stand
66
9.2 Attaching the Optional Arm
The optional arm (or optional stand) can be attached by removing the stand section. Please
refer to our web site for the supported optional arms (or optional stands).
(
When attaching an arm or stand, the installable orientations and movement range (tilt angle)
are as follows:
• Orientation
• Movement range (tilt angle)
Down: 45˚
Up: 45˚
Attention
• When attaching an arm or stand, follow the instructions of the respective User’s Manual.
• When using another manufacturer’s arm or stand, confirm the following in advance and select
one that conforms to the VESA standard:
– Clearance between screw holes: 100 mm x 100 mm
– Arm or stand VESA mount dimensions: 122 mm x 122 mm or less
– Plate thickness: 2.6 mm
– Strong enough to support weight of the monitor unit (excluding the stand) and attachments
such as cables
• Connect the cables after attaching an arm or stand.
• Do not move the removed stand up and down. Doing so may result in injury or device damage.
• The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment
damage.
• Periodically check the tightness of the screws. If the screws are not tight enough, the monitor
may come unattached. This may be the cause of injury or damage.
1. Attach the arm or stand to the monitor.
For installation, use commercially available screws that meet the following conditions:
– Nominal diameter: M4
– Length: Between 8.4 mm and 12.9 mm (if using washers, add the washer thickness)
9.3 Attaching the Original Stand
1. Lay the LCD monitor on a soft cloth spread over a stable and flat surface with the LCD
panel surface facing down.
2. Remove the fixing screws on the optional arm (or optional stand), and detach the
optional arm (or optional stand).
