Edwards ELD500 Series, Инструкция по эксплуатации

Страница: 18 / 121

D13510840D - RC Remote control
Page 8
ELD500 RC Wired
Supplied equipment:

ELD500 RC

Connection cable, 4 m

Operating instructions
ELD500 RC Wireless additional transmitter (for operating a second leak detector)
Supplied equipment:

Radio transmitter

Connection cable

Installation instructions
Installation
Connection to the leak detector
ELD500 RC Wireless
The ELD500 RC Wireless is connected to the leak detector by means of a wireless data
connection.
Connect the leak detector to the radio transmitter for this purpose (see
Connecting the radio
transmitter to the leak detector ).
The ELD500 RC Wireless is shipped set-up for connection with the supplied radio transmitter.
This way, the connection is immediately established upon turning the unit on.
Alternatively, it can also be connected by means of the enclosed cable, similar to connecting
the ELD500 RC Wired. In this case only one connection cable must be used with the ELD500
RC Wireless, not more.
ELD500 RC Wired
The ELD500 RC Wired is connected to the leak detector by connecting the enclosed
connection cable to the RJ25 socket (see Figure 5 ).
Connecting the radio transmitter to the leak detector
Connecting the radio transmitter for the ELD500 RC Wireless:
Use Velcro to position the radio transmitter (1) in a suitable location on the leak detector so
that there is a direct line of sight between the antenna and the remote control.
Connect the connecting cable of the radio transmitter to the RJ25 socket of the leak
detector (2).
Note:
To extend the wireless operating range an extension cable also can be used to position the
radio transmitter away from the leak detector, if reception is poor (e.g. at the ceiling of the
room).