Edwards ELD500 Series, Инструкция по эксплуатации

Страница: 32 / 121

D13510840D - RC Remote control
Page 22
Setting the time:

The fields can be selected individually with "<" and ">".

The field selected for change is marked red.

Make changes via the numeric keypad.

After changing a digit, the red mark automatically changes to the next field.

Confirm the set time with "OK".

The date can be set in the same way.
Operating the leak detector
The "START/STOP" and "ZERO" buttons on the remote control can be used to operate the leak
detector in the same manner as on the actual leak detector.
If the remote control displays a menu page of the configuration, you can change to the status
display of the leak detector with "Back".
The leak detector can be in the modes "Runup" or "Stand-By":
Figure 26
"
Runup
"
and
"
Stand-By
"
status displays
START button
Pressing the START button for the first time activates the leak detector so that it starts
measuring.
If the START button is pressed again while measuring, the maximum leak rate display (holding
function) is activated. This displays the maximum leak rate which has occurred since "START".
Note:
The ELD500 RC Wired cannot store date and time if the connecting cable is removed or the
leak detector is turned off.
Note:
You must observe the operating instructions of the leak detector in any case.