EDNord QMS magicolor 2, Начало работы

Страница: 34 / 96

Installing Options
QMS magicolor 2 Getting Started 2-18
Installing Options
If you purchased any printer options, such as extra memory (SIMMs),
emulations, an interface card, or an internal hard disk, install them now.
If installation instructions are included with the option, follow them. If
not, use the installation instructions in the
Options manual.
Installation Troubleshooting
If you’ve followed all of the instructions in this chapter and still have
problems you can’t solve, see appendix A, “QMS Customer Support,”
for information on getting help.
If you see this... It’s probably
because... Do this...
Colors aren’t
registering properly. The OPC belt
cartridge is not
pushed all the way in. Repeat the steps in “OPC Belt
Cartridge” on page 2-10.
CHECK WASTE
TONER
message
appears in the
message window.
The waste toner pack
isn’t properly
installed. Make sure it sits loosely in its
compartment and that the top of
the pack is not wedged under the
top of the compartment.
Printouts seem
faded on one side of
the page. The printer is not on
a level enough
surface. Level the printer surface. The
slant of the surface holding the
printer should not exceed 1.5°
after the printer is placed on it
(for example, a round pencil laid
on the surface shouldn’t roll in
any direction).
The colors look
drastically wrong. The toner cartridges
are not correctly
installed. Check the toner cartridge
installation. Refer to “Toner
Cartridges” on page 2-12.
The start-up page
comes out skewed. The transfer unit was
jarred open during
the installation and
needs to be closed. Refer to the “Troubleshooting”
chapter in the
Operation guide
for information on opening and
closing the unit.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500