EDNord QMS 1060E, Начало работы

Страница: 81 / 120

If You Have
Trouble
4-19 Connecting to an Ethernet Network
2 Edit the system host table by adding the following line to the
/etc/hosts file:
internetaddress hostname
where internetaddress is the Internet address of the printer
(Administration/Communications/CrownNet/TCPIP/Internet
Address menu) and
hostname is the name of the host.
3 If necessary, set the hardware address.
▲
Caution : We strongly recommend that you do not change the
hardware address.
If you’re working on a system other than a UNIX system, set the
hardware address through the printer control panel.
If you’re working on a UNIX system, send the hardware address
to the print server by typing
arp -s hostname hardwareaddress temp
↵
ping hostname
↵
where hostname is the name of the host and hardwareaddress is
the hardware address of the printer (in the form ## . ## . ## . ## as
found on the printer start-up page and in the Administration/Com-
munications/CrownNet/Common/HW Address menu).
» Note: You can also send the hardware address of a UNIX system
through the BOOTP and RARP utilities.
If You Have Trouble
If you have trouble connecting and configuring your Ethernet inter-
face, refer to the “Output Problems” section of chapter 6, of the
Operation guide for troubleshooting tips.
EDNord - Istedgade 37A - 9000 Aalborg - telfon 96333500