EDNord QMS 1060E, Начало работы

Страница: 57 / 120

PC Printing
Software
3-11 Connecting to a PC
Verifying the Serial Setting Changes
1 Turn the printer on and off again.
2 Compare the serial port settings listed on the start-up page
to those in your AUTOEXEC.BAT file.
3 Try the communication test again.
If a blank page ejects from the printer, the printer and the PC are
communicating. Skip ahead to “PC Printing Software,” below, to
finish connecting the printer. If a blank page does not eject and
you typed the file correctly, see chapter 6, “Troubleshooting,” of
the
Operation guide, and refer to your DOS documentation for
more information.
PC Printing Software
If you're replacing a PostScript printer, you can probably start printing
now with the printing software already in place. Refer to your applica-
tion documentation for instructions on sending documents to the
printer.
However, if you want to be able to use all your printer's special fea-
tures (like collation, 600x600 dpi printing, and gamma correction), or
if you've never printed to a PostScript printer before, we recommend
you take a few minutes to make sure you have the following printing
software installed:
n
PS Executive Series Utilities
n
A PostScript printer driver
Online/
Offline Put the printer
back on line
(the Ready
indicator lights).
IDLE
» Note:
Shaded table cells indicate that the message scrolls.
EDNord - Istedgade 37A - 9000 Aalborg - telfon 96333500