Edmunds Gages Accu-Setter II, Руководство пользователя

Страница: 55 / 119

PROGRAMMING - MULTIPLE CHECK MEASUREMENT
3-27
MPL CHK
1)
Rotate the ENTER button to select "CHK 1", "CHK 2", or "CHK
3" and then press ENTER.
2) A numerical value with a polarity sign (+ or -) will display. Enter
the correct magnification numeral. If this check is not being
used, change number to 0. Enter the correct polarity by pressing
the enter button to move to the + or - position and rotate enter
button to select your choice.
3) Press the RST button to return to "CHK X" and rotate the
ENTER button to select the next check, if any, used on the
current check and repeat steps 1 - 2. When all check for the
current multiple check have been setup press the RST button
until FUNCTION is displayed.
Range
1)
Rotate the ENTER button until "RANGE" is displayed and then press
ENTER.
2) Rotate the ENTER button until the desired full scale value is displayed
and then press enter. Refer to the Accusetter program guide for the
correct range for a given application.
NOTE: If the scale option of the
Xducer menu is set to INCH then only inch range options will be listed
and if the scale option of the Xducer menu is set to METRIC only
metric ranges will be listed.
Note: .020”/.500mm or .050”/1.00mm ranges should be used for electronic
applications only.
3)
After the desired range is displayed press the ENTER button.
4) Rotate the ENTER button to select "DEVIATN" or "ABSOLUTE" and
then press the ENTER button.
5) If "Deviation" was selected then the Accusetter will return to the define
menu and display "RANGE". If "Absolute" was selected then use the
ENTER button to program the nominal part size. After programming
the nominal size press the RST button until RANGE is displayed.
NOTE: If the RANGE is changed the master sizes and part limits must
also be reprogrammed.