Eaton S611, Руководство пользователя

Страница: 83 / 96

S611 Soft Starter
MN03902011E—May 2012 www.eaton.com
71
Modbus Map, continued
Modbus
Coil Number Modbus
Register Number
R/W DCI Descriptor Notes
— 419 R/W Reserved —
— 420 R/W Reserved —
— 421 R/W Reserved —
— 422 R/W DCI_CURRENT_UNBALANCE_TRIP_LEVEL %, 0–100 (2)
— 423 R/W DCI_CURRENT_UNBALANCE_TRIP_DELAY Seconds 1–20 (5)
— 424 R/W DCI_LOAD_DISCONNECT_TRIP_LEVEL %rated, 1–50 (6)
— 425 R/W DCI_LOAD_DISCONNECT_TRIP_DELAY_SECONDS Seconds, 1–60 (5)
— 426 R/W DCI_LOAD_DISCONNECT_SOURCE 0 = Under power
1 = Under current
— 427 R/W DCI_PHASE_LOSS_TRIP_LEVEL %, 0–100 (40)
— 428 R/W DCI_PHASE_LOSS_TRIP_DELAY Seconds 1–20 (2)
— 429 R/W DCI_UNDER_VOLTAGE_PERCENT %, 1–99 (90)
— 430 R/W DCI_UNDER_VOLTAGE_TRIP_DELAY_SECONDS Seconds 1–60 (10)
— 431 R/W DCI_OVER_VOLTAGE_PERCENT %, 101–120 (110)
— 432 R/W DCI_OVER_VOLTAGE_TRIP_DELAY_SECONDS Seconds 1–60 (10)
— 433 R/W DCI_VOLTAGE_UNBALANCE_PERCENT %, 1–20 (6)
— 434 R/W DCI_VOLTAGE_UNBALANCE_TRIP_DELAY Seconds 1–60 (10)
— 435 R/W DCI_PHASE_SEQUENCE 1 = ABC
2 = ACB
— 436 R/W DCI_FAULT_RELAY_CONFIGURATION 0 = Faulted
1 = Not faulted
— 437 R/W DCI_AUX_RELAY_CONFIGURATION 0 = Faulted
1 = Not faulted
2 = Bypass
3 = Not in bypass
4 = Motor energized
5 = Not motor energized
— 438 R/W DCI_UI_EDIT_LOCK 0 = Unlocked
1 = Locked
— 439 R/W DCI_USER_DISPLAY_CONFIG 0 = Thermal capacity
1 = Power factor
2 = Line frequency
3 = Reserved
4 = Voltage imbal %
5 = Current imbal %
6 = Run time
7 = Average pole temp
8 = Pole A temp
9 = Pole B temp
10 = Pole C temp
— 440 R/W DCI_MODBUS_ADDRESS 1–247 (1)
— 441 R/W DCI_MODBUS_BAUD_RATE 0 = 1200
1 = 2400
2 = 4800
3 = 9600
4 = 19200 (default)
5 = 38400
6 = 57600
7 = 115200
8 = Reserved
Changes take place on next power cycle
www.comoso.com