Eaton PowerXL DM1 Series, Руководство по применению, Страница: 20 / 258

10
Chapter 2 - Keypad overview for DM1 Pro
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES
MN040049EN —September 2021 www.eaton.com
LED lights
Table 4. LED state indicators.
Indicator Description
Run
Green Run:
Indicates that the VFD is running and controlling the load in
Drive or Bypass.
Blinks when a stop command has been given but the drive is
still ramping down.
Fault
Red Fault:
Turns on when there is one or more active drive fault(s).
Remote
Yellow Local/Remote:
Local: If the local control place is selected, turns off the
light.
Remote: If the remote control place is selected, turns on the
light.
LCD display
The keypad LCD indicates the status of the motor and the
drive and any faults in motor or drive functions. On the
LCD, the user sees information about the current location in
the menu structure and the item displayed.
Overview
Five lines shall be displayed in the screen. General view is
as following in Figure 3.
Figure 7. General view of LCD.
Drive Status
Direction Status
Control Place
Menu Location
Soft Key 2
Function Label
Soft Key 1
Function Label
Real Time Clock
(hh:mm)
Active
Selection
The lines definition is as below.
The first line is State line, shows:
•
RUN/STP/NRD/FIM/TFM - If motor is running, the run
state shall display “RUN”, otherwise the state display
“STP”. “RUN” blinks when the stop command is sent
but the drive is decelerating. “NRD” is displayed if the
drive is not ready or does not have a signal “FIM” is
displayed to indicate it is in Fire Mode and the drive is in
a Run state. “TFM” is displayed when in the Fire Mode
Test Mode and the drive is in a Run State.
•
FWD/REV/JOG - If the motor running direction is
clockwise, display “FWD”, otherwise display “REV”.
“Jog” if the drive is in Jog mode the status indication will
occur.
•
KEY/I/O/BPS/RBP/BUS/OFF - If it is in bypass currently,
display “BPS”; when run command is given it will got
to “RBP”. otherwise, if the current control source is I/O
terminal, display “I/O”. If it is keypad, then display “KEY”;
otherwise display “BUS.” If HOA enabled and switch to
OFF, it shall show OFF.
•
PAR/MON/FLT/OPE/QSW/FAV/TPM/MS1/SL1/SL2/
SL3/SL4/BUx - If the current page is parameter menu,
display “PAR”. If monitor menu, then display “MON”. If
fault menu, then display “FLT”. If operation menu, then
display “OPE”. If quick start wizard, then display “QSW”.
If optional card menu, then display “BOA”. If favorite
menu, then display “FAV”. If main menu, then display
“TPM”. When doing the Multi-drive Pump and Fan mode,
the drive mode will be defined with MS- Master and SL
being a slave drive. The 1 through 5 will indicate the
number in the series it is. “BUx” indicates the drive
being a backup drive when in the redundant drive system.
The second line is Code line, shows the menu code.
The third line is Name line, shows the menu name or
parameters name.
The fourth line is Value line, shows the submenu name or
parameters value.
The fifth line is Soft Key line, the functions of Soft Key 1
and Soft Key 2 are changeable, and the real time is in the
middle.