Eaton Power Xpert PXM 4000, Руководство пользователя и инструкция по установке

Страница: 154 / 292

Page 146
IM02601004E
www.eaton.
8 Setup on the Web Server Pages
COM3 (CE4) SETUP
Use the COM3 Setup page to:
• Setup the Modbus RTU as a Master - Gateway, Slave - Gateway, Master - IO, or Modbus Slave.
For Slave, you can choose to communicate via Modbus ASCII or Modbus RTU.
• Select the Modbus Slave addresses.
• Select the Baud Rate, Stop Bits and Parity for the COM3 device on the CE4 RS232 port
These options are the same as for COM1 and COM2 except that COM3 is an RS232 interface for
one-on-one communication or multipoint through a modem.
Note: To use COM3 (RS232) between a Power Xpert Meter Master Gateway and Slave-Gateway,
use a null-modem cable that swaps RX with TX on the 9-pin D connector.
Locating COM3 Setup on the Web
From the Setup Main Page, select Meter Setup & Commissioning from the tree structure on the left
side of the page. The tree structure will expand to list Security, Compensation, Metering, I/O, Clock,
Communications and System. Click Communications. The tree structure will expand to list COM1
& COM2, COM and Ethernet/LAN setups. Click COM3 Setup. The page will update to display the
current COM3 settings.
Click the Edit button at the bottom of the page to modify the current settings. The page will update
to display drop down boxes for use in editing each feature. Use Modbus RTU to select if the device
is a Master - Gateway, Master I/O or a Slave. If Slave is selected, the slave address must be en-
tered in the appropriate text box.
Use the drop down box beside Baud Rate to select the appropriate rate; 9600, 19.2K, 38.4K,
57.6K, 115.2K. Use the drop down box beside Stop bits to select 1 or 2. Click the Parity drop down
box to select None, Odd, or Even.