10
EATON
ET5050 Crimp machine operator´s manual E-EQCR-TT003-E2 May 2019
Tooling removal - using
Quick Die Change (QDC) tool
When prompted to make a tooling change, close the head
to the QDC position. Head will stop and light will no longer
illuminate when in QDC position.
Gradually retract the crimp head completely until the crimp
die holding pins have completely disengaged from the
intermediate dies.
Place the crimp dies into the storage rack, rotate the QDC to
the left, (counter clockwise) this locks the die segments into
the storage rack.
Figure 9
Figure 11
Figure 12
Step 1
Step 3
Step 4
Align the eight pins on the QDC tool with the holes on
the crimp dies, insert the pins fully into the crimp dies
until magnets are fully seated.
Figure 10
Step 2
