12
Technical Data
25-16733-A
Effective
October 2019
Installation and operation manual for
conventional fire panels
EATON
www.eaton.com
Panel Installation
NOTE
THE FOLLOWING INSTRUCTIONS MUST BE FOLLOWED
WITH MAINS AND BATTERY SUPPLIES DISCONNECTED
UNLESS OTHERWISE STATED.
NOTE
THE PANEL SHOULD BE INSTALLED IN A CLEAN, DRY,
REASONABLY WELL VENTILATED PLACE, AND NOT IN
DIRECT SUNLIGHT. TEMPERATURES IN EXCESS OF
40°C AND BELOW 5°C MAY CAUSE MALFUNCTIONS,
IF IN DOUBT CONSULT EATON ELECTRICAL SYSTEMS.
THE PANEL SHOULD BE LOCATED AWAY FROM ANY
POTENTIAL HAZARD, IN A POSITION WHERE IT IS
READILY ACCESSIBLE TO AUTHORISED STAFF, AND
THE FIRE SERVICES, IDEALLY ON THE PERIMETER OF A
BUILDING NEAR A PERMANENT ENTRANCE.
Mounting the Panel
To prepare the panel for mounting, you need to remove the front
cover of the panel, and the PCB shelf and the PSE from the back
box .
•
To remove the front cover of the panel, unscrew the two retain-
ing screws located at the top corners of the panel . See Figure
13 .
•
It is recommended to remove the PCB shelf and the PSE from
the back box before drilling the holes .
•
To remove the PCB shelf push the clips down
①
, then push
the shelf towards the top of the back box and then lift forwards
②
. See Figure 14 .
Figure 13. Remove Panel front cover
Figure 14. Remove the PCB shelf
