14
Technical Data
25-16733-A
Effective
October 2019
Installation and operation manual for
conventional fire panels
EATON
www.eaton.com
•
If the panel is being wall mounted then cut out the required
number of cable entry holes in the back using a 20mm hole
saw with pilot drill bit as shown in Figure 17 . Fit the glands to
the back box and pull through the required cables .
•
Using the mounting holes in the back box, drill holes into the
wall and insert wall plugs and secure the panel to the wall as
shown in Figure 18 . Ensure any dust is cleaned from the back
box .
•
Secure the PSE PCB back into the back box by following the
reverse instructions on the previous page (see Figure 15 and
Figure 16) .
•
Fit the PCB shelf and cables by following the reverse instruc-
tions (see Figure 14 on page 12) .
•
If the panel is wall mounted, pull the cabling through the glands
ready for wiring .
•
Fit the door back onto the back box by following the reverse
instructions on the previous page (see Figure 13) .
Figure 17. Cut Cable entry holes
Figure 18. Secure the panel to the wall
