26
Technical Data
25-16733-A
Effective
October 2019
Installation and operation manual for
conventional fire panels
EATON
www.eaton.com
Self-test Mode
This function is only available at access level 3 .
•
Enter the access code 2321 .
•
Press the
Test
button
②
.
•
The
Test
indicator will slow flash and the buzzer will give a slow
pulsing tone .
•
The fire indicator on every detector head will turn on .
•
This function is useful for checking that each head is fitted
correctly as the fire indicator will not turn on .
To end the self-test mode, enter the access code 2321 and press
button
②
.
Walk Test Mode
This function is only available at access level 3 .
•
Enter the access code 2321 .
•
Press
Indicator Test
button
③
.
•
The Test indicator will turn on and the buzzer will give a slow
pulsing tone .
•
This function places all zones in test mode and is used during
commissioning to test every fire detection device on a zone .
•
Repeat the following for each zone (with fire detection devices)
in turn:
•
Activate the fire detection device or manual call point on the
zone .
•
All fire alarm devices will sound on all zones for 3 seconds
and then will automatically silence .
•
The fire panel will then reset the zone from the fire condition .
•
Repeat the above process until all fire detection devices and
manual call points on the zone have been tested .
To end the walk test mode enter the access code 3112 or 2321
and press the
Reset
button .
If no fire detection device or manual call point is triggered within
10 minutes of the walk test being started, the test mode will
timeout and return back to access level 1/normal condition .
