
5. Commissioning
5. Commissioning
When the easyE RTDs are used as intended, they will often be installed in a machine
or system to function as controls and will be wired accordingly.
In this case, the RTDs will need to be switched on and off using the corresponding
machine controller.
DANGER!
Electric shock hazard!
When setting up and testing the visualization interface, make sure to
use a test environment that is fused as per the state of the art and in
accordance with all applicable standards in order to power the
devices.
The RTD will boot up as soon as it is energized.
If the RTD will not start, or if an error message appears, consult the → Section
"Faults", page 97 section.
The RTD will be shut down as soon as it is not being powered.
CAUTION
SHORT-CIRCUIT HAZARD
If the Resistive Touch Display is or has been exposed to envir-
onmental fluctuations (ambient temperature, air humidity), con-
densation may form on or inside RTD. As long as this condensation is
present, there will be a short-circuit hazard.
Do not switch on the device when it has condensation in or on it.
If the Resistive Touch Display has condensation in or on it, or if it has
been exposed to environmental fluctuations, let the RTD settle into
the existing ambient temperature before switching it on. Do not
expose the device to direct thermal radiation from heating appli-
ances.
Power the RTD with 24 VDC.
The RTD unit will boot up. As soon as the operating system loads, the easyE Remote
Touch Display application will start.
In the case of brand new devices, the Setup Wizard will start directly.
easyE Remote Touch Display
01/24 MN048027EN Eaton.com
55
Содержание easyE
