Eaton easyE, Руководство пользователя, Страница: 45 / 111

3. Installation
3.5 easyE RTD mounting
3.5 easyE RTD mounting
1. Insert the RTD into the mounting cutout from the front.
TOP
Fig. 8: Mounting in the installation cutout
2. As long as the device has not been secured with all holding brackets, make
sure to secure it so that it will not fall down.
3. Insert the holding brackets into the first device cutout intended for this pur-
pose.
> 0.08 ≦ 0.1 Nm
(> 0.70 ≦ 0.86 lb-in)
3
4
Fig. 9: Installing the holding brackets
4. Tighten the set screw until it comes into contact with the installation surface.
5. Follow steps 3 and 4 to insert the next holding bracket at a 90° angle to the
last one you inserted.
6. Repeat steps 3 and 4 until all necessary holding brackets are installed.
7. Check that the device is in its correct, centered position and that the gasket is
in contact all around; adjust if necessary
8. Tighten the set screws in a criss-cross sequence with a max. torque of >0.08
≦ 0.1Nm (>0.70 ≦ 0.86 lb-in).
easyE Remote Touch Display 01/24 MN048027EN Eaton.com
45