Eaton DuraForce HMR Series, Руководство пользователя

Страница: 14 / 24

14
EATON
Duraforce HMR Conversion Procedures Manual E-MOPI-TM005-E July 2012
HMR Motor Control
with Pressure Compensator,
Electric DOR, and Brake
Pressure Shut-off
S.H.C.S.
(2 Places)
O-Ring
(5 Places)
Standard HMR Motor
Control with Pressure
Compensator and DOR
Exchange Controls
Set Up and Procedure
Procedure to Exchange Motor Controls
Note This procedure must be performed in a
clean environment using clean Parts, Tools and
Lubricants
Remove the existing motor control by removing the
two S.H.C.S. with the 6mm Allen wrench. Keep the
two S.H.C.S. for reuse.
Make sure to remove the five O-Rings with the
existing control.
Prior to installing the new motor control, verify
that the five O-Rings are in good condition (i.e not
damaged) and are properly positioned in the O-Ring
grooves.
Install the new motor control and fasten it with the
two S.H.C.S. from step #1.
Tighten the S.H.C.S. with the 6mm Allen wrench and
torque each one to 32 N-m (24 ft-lb).
1
2
3
4
5