4 Operation
4.3 Commissioning with control signal terminals (default settings)
DC1 Frequency Inverter
10/12 MN04020003Z-EN
www.eaton.com
85
4.3 Commissioning with control signal terminals (default settings)
DC1 frequency inverters are set in the factory and can be started directly via
the control signal terminals by connecting the motor outputs allocated for the
mains voltage (see connection example below).
Following are a series of simplified connection examples that use the default
configuration:
NOTICE
Any contactors and switching devices on the power side are not
to be opened during motor operation. Inching operation using
the power switch is not permitted.
Contactors and switchgear (repair and maintenance switches)
on the motor side must not be opened while the motor is in
operation.
Inching operation of the motor with contactors and switching
devices in the output of the frequency inverter is not permitted.
NOTICE
Make sure that there is no danger in starting the motor. Discon-
nect the driven machine if there is a danger in an incorrect oper-
ating state.
→
If motors are to be operated with frequencies higher than the
standard 50 or 60 Hz, then these operating ranges must be
approved by the motor manufacturer. The motors could be dam-
aged otherwise.
→
You can skip this section if you want to set up the parameters
directly for optimal operation of the frequency inverter based on
the motor data (rating plate) and the application.
Содержание DC1-12011 Series
