Eaton DC1-12011 Series, Руководство пользователя

Страница: 109 / 194

6 Parameters
6.1 Operating unit
DC1 Frequency Inverter 10/12 MN04020003Z-EN www.eaton.com
105
6.1.1 Display unit
The display unit is a 7-segment LED display with five decimal points. The
LED segments are red.
Figure 57: 7-segment LED display
6.1.2 Menu Navigation
When the specified supply voltage (L1/L, L2/N, L3 connection terminals) is
applied, the DC1 frequency inverter will automatically perform a self-test:
The LED display will light up and, depending on the selected operating mode,
will display “Stop“ or the appropriate value.
6.1.3 Setting parameters
The following table shows a good example of the general execution for
selecting and setting parameters.
￫
When operating values are displayed (i.e. STOP is not displayed),
the frequency inverter will issue an automatic start command.
￫
The flashing digit on the right indicates that the value being dis-
played can be changed with the arrow buttons (Up
▲ or Down ▼ ).
Sequence Commands Indicator Description
0 Stop status: The frequency inverter is ready for operation.
1 Hold down the OK button for about a second.
Parameter P-01 will be displayed (the digit on the right, “1“, will
flash)
2 Press OK button
The display will switch to H 50.0 (= 50 Hz), the digit on the right,
“0“ will flash.
The value can be confirmed and automatically stored by pressing
the OK button. The display will jump back to the parameter name
(P-01).
The numerical first value is always shown from the selected main
menu.
Example: Main menu PAR, Parameter P1.1
The display automatically switches between the parameter
number and the defined value.
P1.1 =1 is displayed at the first switch on and after the default
settings have been activated.