![background image](http://html1.mh-extra.com/html/eaton/cutler-hammer-easy-start-es-series/cutler-hammer-easy-start-es-series_instruction-manual_3854391073.webp)
Easy-Start ES Instruction Manual
Options
SECTION 4
4-2
Available Options
All Easy-Start ES options are available as
factory installed for enclosed models
only and
must be ordered with Easy-Start ES. By
checking the nameplate or by visual inspection it
can be determined what options are supplied with
a unit.
Operator Devices:
Following is a list of
available options.
Cat. No. Suffix
Description
A
Start (Green), Stop (Red),
Reset (Gray) pushbuttons.
B
Hand-Off-Auto Selector
Switch (Gray), Reset
(Gray) pushbutton.
A2
Start (Green), Stop (Red),
Reset (Gray) pushbuttons
and Hand-Off-Auto Selector
Switch (Gray). In Hand
position the unit is
controlled by start stop
pushbuttons and in Auto
position it is controlled by a
remote maintained contact
input.
F2
Ammeter 1-Phase.
F3
Ammeter 3-Phase with
Switch.
G2
Voltmeter 1-Phase.
G3
Voltmeter 3-Phase with
Switch.
H
Elapsed Time Meter.
L5
Power
ON
- Red push-to-
test pilot light.
L6
RUN
- Green push-to-test
pilot light.
L4
TRIP
- Amber push-to-test
pilot light.
R
RESET
- Pushbutton
(Gray)
Control Devices:
Cat. No. Suffix
Description
Y
Auxiliary run relay 2 N.O. 2
N.C. contacts, unwired.
Coil rating 110/120 VAC
Contact Rating 10 Amps AC
Hevi-Duty Company Transformer Connections
T
150VA control power
transformer with 2 primary
fuses.
Easy-Start ES models have multi-voltage ratings.
Each model is factory wired for the following
incoming line voltage for Hevi-Duty Company
transformer:
Easy-Start ES
Voltage Rating
CPT Wired For
208/230/460
460V
380/415
380V
460/500/575
575V
If the incoming line voltage is different than the
one shown in above table, reconnect the CPT
primary and secondary as follows:
Primary
Line
FU-2
Secondary Secondary
Voltage
Connection Connection
Voltage
208 VAC
H2
X4
110 VAC
230 VAC
H2
X3
115 VAC
380 VAC
H3
X4
120 VAC
415 VAC
H3
X3
120 VAC
460 VAC
H4
X3
115 VAC
500 VAC
H5
X4
110 VAC
575 VAC
H5
X3
115 VAC
The primary to FU-3 is factory connected to H1.
One secondary lead is factory connected to X1.
The X1 and H1 connections remain the same for
all line voltages.
StockCheck.com