Eaton 93E 30EBC, Руководство по установке

Страница: 35 / 60

Eaton 93E External Battery Cabinet Installation Manual P-164000057—Rev 05 27
NOTE Use leveling feet only to lock the cabinet in place. Using the leveling feet to raise the
cabinet may result in serious injury to personnel or damage to the cabinet.
14. Lower the EBC cabinet feet and using a level, adjust the cabinet height accordingly until the cabinet is
level.
15. If permanently mounting the EBC, proceed to Step 16 ; otherwise, continue to Step 18 .
16. Using the retained hardware, reinstall the shipping brackets removed in Steps Step 4 and Step 5 to the
front and rear of the EBC with the angle facing outward (see Figure 12 and Figure 13 ).
17. Secure the cabinet to the floor with customer-supplied hardware.
18. If installing a second EBC, repeat Step 1 through Step 17 ; otherwise, proceed to Step 19 . Install the
second EBC on the right side of the first EBC.
19. Proceed to paragraph 4.3 Installing Power Terminal Cover Base .
44..22..22 U Unnllooaaddiinngg tthhee 6600EEB BC C
The EBC is bolted to a pallet consisting of four metal angle supports secured to two wood supports.
To remove the pallet:
1. If not already accomplished, use a forklift or pallet jack to move the EBC to the installation area, or as close
as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the supports on
the bottom of the pallet (see
Figure 9 for the EBC cabinet center of gravity measurements).
2. Open the front door (see Figure 15 ) by lifting the latch from the bottom and turning to the right
(counterclockwise) and swing the door open.
3. Locate the four 1/2" jacking bolts from the parts kit and install them in the threaded holes in the front and
rear supports as shown in
Figure 15 . Place a floor protector from the parts kit underneath each jacking bolt,
and screw the bolts down against them.
The floor protectors protect the floor from being marred by the jacking bolts.
4. Loosen, but do not remove, the skid mounting bolts holding the pallet skids to the front and rear supports
(see
Figure 15 ).
WARNING
RISK OF INSTABILITY. Turning the jacking bolts unevenly may cause the cabinet to become unbalanced. To
prevent tipping the cabinet, raise and lower the jacking bolts evenly.
CAUTION
CABINET MAY TIP. Raise the EBC no more than 3 mm (1/8") above the floor (just enough to allow the removal
of the pallet skids).
5. Turn each jacking bolt consecutively, two full turns, until the pallet skids clear the floor by approximately
3 mm (1/8").
6. Remove the hardware loosened in Step 4 . Pull the two pallet skids out from under the front and rear
supports. Recycle the pallet skids and hardware in a responsible manner.
CAUTION
CABINET MAY FALL. Do not loosen the hardware attaching the front supports to the cabinet base. The cabinet
must be lowered by the jacking bolts before the supports can be removed.
Installation