Eaton 93E 30EBC, Руководство по установке

Страница: 36 / 60

28 Eaton 93E External Battery Cabinet Installation Manual P-164000057—Rev 05
7. Carefully and evenly lower the cabinet by turning each jacking bolt consecutively two full turns
(maximum) until the casters contact the floor and the cabinet is no longer supported by the jacking bolts.
8. After the EBC is resting on the floor, remove the jacking bolts and floor protectors. Recycle them in a
responsible manner.
9. Remove the cabinet mounting bolts holding the front and rear supports to the cabinet base (see Figure 15 ).
10. If installing the cabinet permanently, retain the cabinet mounting bolts; otherwise, recycle the bolts along
with the support brackets in a responsible manner.
11. Close the door and secure the latch.
12. If the leveling feet are not retracted, turn all four leveling feet until they are retracted as far into the cabinet
as possible.
13. Roll the EBC to the final installation location on the right side of the UPS cabinet making sure the doors are
flush with each other.
NOTE Use leveling feet only to lock the cabinet in place. Using the leveling feet to raise the
cabinet may result in serious injury to personnel or damage to the cabinet.
14. Lower the cabinet feet and using a level, adjust the cabinet height accordingly until the cabinet is level.
15. If permanently mounting the EBC, proceed to Step 16 ; otherwise, continue to Step 19 .
16. Locate the two floor mounting brackets from the parts kit.
17. Using the retained cabinet mounting bolts, install the floor mounting brackets to the front and rear of the
EBC with the angle facing outward.
18. Secure the cabinet to the floor with customer-supplied hardware.
19. If installing a second EBC, repeat Step 1 through Step 18 ; otherwise, proceed to Step 20 . Install the
second EBC on the right side of the first EBC.
20. Proceed to paragraph 4.3 Installing Power Terminal Cover Base .
Installation