Eaton 93E 30EBC, Руководство по установке

Страница: 31 / 60

Eaton 93E External Battery Cabinet Installation Manual P-164000057—Rev 05 23
C Chhaapptteerr 44 IInnssttaallllaattiioonn
44..11 P Prreelliim miinnaarryy IInnssttaallllaattiioonn IInnffoorrm maattiioonn
WARNING
Installation should be performed only by qualified personnel knowledgeable of batteries and the required
precautions.
Refer to the following while installing the External Battery Cabinet (EBC):
• Chapter 3 Installation Plan and Unpacking for cabinet dimensions, equipment weight, wiring and terminal
data, and installation notes.
• Do not tilt the cabinets more than 10° during installation.
44..22 U Unnllooaaddiinngg tthhee EEB BC C C Caabbiinneett ffrroom m tthhee P Paalllleett
WARNING
The EBC is heavy (see Table 1 ). If unpacking and unloading instructions are not closely followed, the cabinet
may tip and cause serious injury.
CAUTION
• Do not tilt cabinet more than 10° from vertical.
• Lift the cabinets only with a forklift or damage may occur.
NOTE 1 The EBC uses inline wheels, not swivel casters. When moving the EBC, move the
cabinet in straight lines as much as possible, minimizing turns.
NOTE 2 For the following procedures, verify that the forklift or pallet jack is rated to handle the
weight of the cabinet (see
Table 1 for cabinet weights).
44..22..11 U Unnllooaaddiinngg tthhee 3300EEB BC C
The EBC is bolted to a wooden pallet supported by wood skids.
CAUTION
• Ensure a minimum of 10 feet behind the EBC for unloading. The area behind the EBC must be
unobstructed.
• The unloading floor must be smooth, with no cracks or large seams to prevent a smooth rolloff of the
cabinet.
To remove the pallet:
1. If not already accomplished, use a forklift or pallet jack to move the EBC to the installation area, or as close
as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the supports on
the bottom of the pallet (see
Figure 6 for the EBC cabinet center of gravity measurements).