U Page 51
Digital controller RK 4004
Example :
The "I target-> CAN" and "Disable I Loop" functions are required.
Sum value = 0005
h
+ 0008
h
= 000D
h
Parameter value = 000D
.9.9. operatorkey config
This parameter is used to activate or deactivate certain functions. The
table below lists the functions:
Function
Value
Description
[ ] Auto: use all sens
0001
h
In "automatic" mode all edge sensors featured in this group are selec-
ted.
[ ] Auto: take photo
0002
h
On selecting "automatic" mode a guiding photo (take photo) is trigge-
red.
[ ] force support free
0004
h
When the "park sensor" key is pressed or signal supplied to the input
of the same name on a digital interface the sensors are moved to their
outer position and main mode set to "
SystemLocked". The system is
only enabled once the "park sensor" key is released or signal no lon-
ger supplied to the input of the same name on a digital interface.
[ ] Center: sup. free
0008
h
In "center position" mode the positioning carriages/sensors are moved
to their outer position. In "automatic" mode the positioning carriages/
sensors move to their origin position or in "hybrid" mode so that they
are symmetrical to the machine center.
[ ] unused sup. free
0010
h
In "automatic" mode non-selected sensors mounted on a motor-driven
positioning carriage, are moved to their outer position. (not active at
present)
[ ] Auto. SensorFree
0020
h
If, during "search for edge" mode the inner end position of the posi-
tioning carriage is reached, "park sensor" mode is automatically swit-
ched to. This value must be set in the controller card X.5 (Master). If
no controller card with address X.5 is featured, the function must be
set on the controller card with activated MCP (MasterControlProces-
sor) (see parameter .9.7. function config 1 / Wert 0100).
[ ] Sens sel. direct
0040
h
Without this setting "manual" mode will always be switched to when a
sensor is selected. If this function is set the selected operating mode
is retained when a sensor is selected.
[ ] emergency sensor L 0080
h
Emergency guiding with left sensor
[ ] emergency sensor R 0100
h
Emergency guiding with right sensor
(*) lost web ----
0000
h
On the loss of the web edge no change to the operating mode is per-
formed.
( ) lost web: Center
1000
h
On the loss of the web edge "center position" mode is switched.
( ) lost web: Manual
2000
h
On the loss of the web edge "manual" mode is switched.
The functions may be selected directly with a CANMON program or
command station DO 200..
If these two options are not available the sum of the required
functions must be formed and this sum value entered in this parame-
ter.
