U Page 21
Digital controller RK 4004
1 = Reset guider
In this reset all parameter values for the selected device are sa-
ved and a restart performed. Every time parameter values are
changed setup mode should always be quit via 1 to assure that
all changed parameter values are saved.
2 = Save parameters
Function 2 is identical to function 1, the only difference is that
no restart is performed for the selected device.
10 = Actuator initialisation run (with specification of the motion
path)
Prior to the initialisation run the actual positioning path must be
established and entered in parameter ".2.5. total motion range".
The actuator initialisation run is started by entering the value
10. Prior to starting the actuator should be located in its center
position for this start position is saved as the new center positi-
on. The latter may also be corrected manually at any time via
parameter ".3.1. center offset".
11 = Initialisation run-support beam
By entering value 11 the initialisation run for all support beams
featured in this group is performed.
12 = Initialisation run-actuator (with specification of motor and
gear data)
In this initialisation run by first entering the motor and gear data
(parameter .3.4./.3.5./.3.6. and .3.7.) the maximum positioning
path is established and entered in parameter ".2.5. total motion
range".
13 = Capture of guiding criterion photo
On follow-up control systems the position of the actuator/tool is
controlled according to the detected web position. In order to
calibrate the offset, a guiding criterion photo of the actuator
must be taken. To this end, the actuator is moved to the requi-
red location manually. While the actuator guiding criterion photo
is being taken, the offset is calculated on the basis of the cur-
rent actuator position and the web position and entered in para-
meter ".4.6. photo auto offset".
22= Save system parameters
The parameter values of certain parameters are additionally
stored and not deleted in the case of possible data memory de-
letion. The following parameters are saved: .8.2. / .8.3. / .8.4. /
.8.5. / .8.6. / .9.2. / .9.7. / .9.8. und .9.9. .
30 = general web guider basic parameter setting
31 = VS 35 .. support beam basic parameter setting
32 = 3 position controller basic parameter setting
33 = VS 50.. support beam basic parameter setting
The device-specific parameters are preset for the specified de-
vices by entering the appropriate value.
