Dynisco TX180, Инструкция по установке и эксплуатации

Страница: 5 / 52

TX180 Temperature Transmitter 5
P
REFACE
N
OTICE
Read this manual before working with these products. For personal and system safety, and for the
optimum product performance, make sure you thoroughly understand the contents before using or
servicing this product.
For technical assistance from the factory please contact:
DYNISCO INSTRUMENTS
38 Forge Parkway
Franklin, MA 02038
Telephone: (508) 541-9400 or 1-800-221-2201
Facsimile: (508) 541-9436
Internet Address: www.dynisco.com
E-mail: salesinst@dynisco.com
1. I
NTRODUCTION
The TX180 is a transmitter that accommodates any one of eleven types of thermocouples, six types
of RTD’s, millivolt or ohm inputs. The unit is precision linearized to the measured temperature over
the entire usable range of the selected sensor. This transmitter is simple to set up and operates much
like high performance analog transmitters.
The TX180 also has numerous advanced features that are achieved through the use of digital signal
processing and micro-controller technologies. Typical of these features are the precision
linearization, the independent zero and full scale settings, digital filtering, etc. Other advanced
features, such as the automatic self diagnostics, and the exceptional stability are transparent to the
user and are continuously active.
The TX180 transmitter can also accept one of two optional plug-in displays. The LI-1 is an
inexpensive, single line display that is intended to give a low-cost, local indication of the measured
temperature. The LI-2 two line display will give a local indication and functions as a very easy-to-use
set-up tool. Both displays facilitate local configuration and ranging of the transmitter.
This manual is divided into several sections. After a brief INTRODUCTION, the section on
UNPACKING AND INSTALLATION contains much useful information for the first time installer. The
section called IN A HURRY? helps get the system operating provided the sensor and transmitter
were purchased at the same time and thus most of the set up was completed at the factory. The next
two sections explain the method of CONFIGURATION using either display. Finally, there is
additional APPLICATION INFORMATION and the TECHNICAL SPECIFICATIONS included in the