Dynisco TX180, Инструкция по установке и эксплуатации

Страница: 18 / 52

18
NOTE: This is the 100
⍀
Platinum DIN with
␣
= 0.00385. This sensor will give superior
measurement results in most real-world situations where the measured temperature is under
1,000
°
F.
NOTE: This is the 100
⍀
SAMA Platinum Curve, known variously as the SAMA RC21-4 or SAMA
PR-279. Constants are 98.13
⍀
@ 0
°
C, with
␣
= 0.00385.
NOTE: The 4W SPEC or Special 4 wire RTD input is reserved for a special RTD input, should one
be desired. Any special 4-wire RTD must be ordered from the factory.
NOTE: The HHTONLY is for a Hand-Held set-up. This is used for Factory set-up only.
Pressing
NEXT
key again returns you to the J thermocouple selection. Repeated pressing of
NEXT
key will again cycle you through the input selection submenu. You can stop at any one of the
thermocouple, RTD or mV selections by pressing the
ENTER
key. This action changes the
transmitter mode to that sensor. If no sensor change is desired, then, without sequencing through the
various sensor options, but jus pressing the
ENTER
key will allow one to confirm the sensor
selection and leave it unchanged. Assume that the sensor is left as T/C J. After pressing
ENTER
the
display will return to the main menu entry of
SELECT INPUT
. Pressing the
NEXT
key then takes
the transmitter to the next main menu selection.
4.4 S
ELECT
U
NITS
If the selected sensor is a thermocouple or RTD, the next menu entry is
SELECT UNITS
.
4W SAMP
4W SPEC
MV
HHTONLY
T/C B
T/C C
T/C E
SELECT UNITS?