Dynisco TX180, Инструкция по установке и эксплуатации

Страница: 24 / 52

24
indicating that the existing offset is set to “plus” 0000.0
°
F. The question mark “?” indicates a
question asking if this value is to remain positive (PLUS ?). By repeatedly pressing the
NEXT
key the
display will alternate
After deciding whether the offset value is to become negative (MINUS), press the
ENTER
key. In this
example the offset is assumed to be negative and a minus sign will be carried through this example.
The display then changes to read:
and the leftmost digit position will start blinking (shown here in italics) asking if the thousand’s
position needs to be changed. To change the thousands position, start pressing the
NEXT
key and
the leftmost digit will increment through 1 2 3 4 5 6 7 8 9 0. Stop pressing the
NEXT
key at any of
the numerals desired, then press
ENTER
to accept the selection. If the numeral selected before
pressing
ENTER
was 0, then the display would change to
and the second digit from the left will start blinking (shown here in italics) asking if the hundreds
position needs to be changed. As before, to change the number in this digit position repeatedly press
the
NEXT
key until the desired numeral is reached. Then press
ENTER
to go to the next lower
significant digit position. Each time the
NEXT
key cycles through the ten choices for that digit
position and the
ENTER
key enters the selected number. The digit position being changed is the one
that is blinking. The legend on the display will change successively to
After the tenth’s digit position has also been changed to the desired value, the next pressing of the
ENTER
key returns the transmitter to the alternating display of
TRIM DISPLAY
. Since changing of
-0000.0
°
F
MINUS?
0000.0
°
F
PLUS?
0000.0
°
F
THOUSN?
0 000.0
°
F
HUNDRD?
00 00.0
°
F
TENS?
000 0.0
°
F
ONES?
0000. 0
°
F
TENTHS?