Dynisco TX180, Инструкция по установке и эксплуатации

Страница: 25 / 52

TX180 Temperature Transmitter 25
the offset value has just been completed, press the
NEXT
key to proceed to the next menu selection.
Note, if trimming the transmitter to external devices is desirable, it may be necessary to trim the 4
and 20mA output
after setting the display offset.
4.12 S
ELECT
L
ANGUAGE
The 2-line display provides the option of changing the language from English to French, German or
Spanish.
To change the language of the unit.
Sequence through the screen until you reach the language you would like, After selecting the
language, press the
ENTER
Key to confirm.
English Deutsch French Espanol
If all of the set-up and re-ranging operations have been satisfactorily completed, then pressing
ENTER
will return the transmitter to the normal operate mode. Pressing the
NEXT
key at this point
will return the display to the first screen in the sequence, Select Input.
Note again, that whenever the transmitter is in the display set-up mode, if no activation of the
pushbuttons occur for approximately 2-1/2 minutes, the transmitter returns to the operate mode.
One can also return to the operate mode at any point while in the
DISPLAY MODE
by removing
power from the transmitter for about 10 seconds, then reapplying power.
NOTE: Pressing
ENTER
stores new values in transmitter. To expace at any point, or to retain
original values (before pressing
ENTER
to accept new value): disconnect power and wait
30 seconds. Reconnect power & transmitter will start up in Operate Mode.
SELECT LANGUAGE
ENTER
RETURN TO OPERATE MODE?