Dynisco TX180, Инструкция по установке и эксплуатации

Страница: 44 / 52

44
A variety of signal conditioners, thermocouples are also available.
* The LI-1 or LI-2 can be used for setup and configuration for transmitters installed in XP-HEAD or
WP-HEAD housings, but cannot be installed permanently. The XP-HEAD and WP-HEAD will not
close properly with either of these displays installed.
8. S
PECIFICATIONS
THERMOCOUPLE SENSORS:
NIST Types B, C, E, J, K, N, R, S, & T; DIN Types L & U
RTD Resistance Sensors:
100
⍀
Pt DIN curve (
␣
= 0.00385) 2, 3 or 4 Wire
100
⍀
Pt SAMA RC21-4 curve (
␣
=0.003923) 2, 3 or 4 Wire
100
⍀
Ni DIN curve 2, 3 or 4 Wire
120
⍀
Ni MINCO curve 2, 3 or 4 Wire
10
⍀
Cu curve 2, 3 or 4 Wire
Ni SAMA 2, 3 or 4 Wire
MILLIVOLT INPUT RANGE:
-15 to 115mVDC
THERMOCOUPLE AND RTD LINEARIZATION:
Linearization with temperature conforms to NIST & DIN curves within
±
0.05
°
C.
OUTPUT:
Analog, Two wire 4 to 20mA; Digital via HART
OUTPUT RANGING ADJUSTMENTS:
Analog Zero {100% of sensor range, non-interacting}
Full Scale {Normal or reverse acting}
MINIMUM OUTPUT RANGE:
None
OUTPUT RESOLUTION:
Analog, 3.6
␮
A
TRANSMITTER ACCURACY:
±
0.05% of the millivolt or ohm equivalent reading, or the accuracy from the table below, whichever
is greater; plus the effect of cold junction measurement error or
±
0.5
°
C (
±
0.9
°
F), if using a
thermocouple sensor; plus
±
0.05% of span.