Dynisco TX180, Инструкция по установке и эксплуатации

Страница: 20 / 52

20
After deciding whether the zero value, LRV, is to remain positive (PLUS), press the
ENTER
key. In
this example assume it is to remain positive. The display changes to read:
and the left most digit position will start blinking (shown here in italics) asking if the thousands
position needs to be changed. To change the thousands position, start pressing the
NEXT
key and
the left most digit will increment through 1 2 3 4 5 6 7 8 9 0. Stop pressing the
NEXT
key at any of
the numerals desired, then press Enter to accept the selection. If the numeral selected before
pressing
ENTER
was 0, then the display would change to read:
and the second digit from the left will start blinking (shown here in italics) asking if the hundreds
position needs to be changed. As before, to change the number in this digit position repeatedly press
the
NEXT
key until the desired numeral is reached. Then press
ENTER
to go to the next lower
significant digit position. Each time the
NEXT
key cycles through the ten choices for that digit
position and the
ENTER
key enters the selected number. The digit position being changed is the one
that is blinking. The legend on the display will change successively to read:
After the tenth’s digit position has also been changed to the desired value, the next pressing of the
ENTER
key returns the transmitter to the alternating display of
CHANGE ZERO
. Since changing of
the zero has just been completed, press the
NEXT
key to proceed to the next menu selection,
CHANGE FULL SCALE
.
4.6 C
HANGE
F
ULL
S
CALE
0040.0
°
F
THOUSN?
0 040.0
°
F
HUNDRD?
00 40.0
°
F
TENS?
004 0.0
°
F
ONES?
0040. 0
°
F
TENTHS?
200.0
°
F
CHANGE
200.0
°
F
FULL
200.0
°
F
SCALE?