Dynapac CA270, Инструкция по эксплуатации

Страница: 86 / 99

Maintenance - 250h
ICA270-IN2EN1.pdf 2012-11-05
Battery cell
Fig. Electrolyte level in battery
1. Cell cap
2. Electrolyte level
3. Plate
10 mm
(0.4 in)
1
2
3
Take off the cell caps (1) and make sure that
electrolyte (2) is about 10 mm (0.4 in) above the plates
(3). Check the level of all cells. Top off with distilled
water to the right level if the level is low.
If the ambient temperature is below freezing, run the
engine for a while before topping off with distilled
water. Otherwise the electrolyte might freeze.
Make sure that ventilation holes in the cell cover are
not clogged, then put the cover back on.
The cable shoes should be clean and well tightened.
Clean corroded cable shoes and grease them with
acid-free Vaseline.
Always disconnect the negative cable first when
disconnecting the battery. When connecting the
battery, always connect the positive cable first. Always disconnect the negative cable first when
disconnecting the battery. When connecting the
battery, always connect the positive cable first.
Discard used batteries wisely. Batteries contain
lead, which is harmful to the environment. Discard used batteries wisely. Batteries contain
lead, which is harmful to the environment.
Before doing any electric welding on the machine,
disconnect the battery ground cable and then all
electrical connections to the alternator. Before doing any electric welding on the machine,
disconnect the battery ground cable and then all
electrical connections to the alternator.
78