Dynapac CA 152, Инструкция по эксплуатации

Страница: 99 / 119

Maintenance - 250h
ICA152-4EN3.pdf 2012-06-12
Bolted joints - Checking tightening torque
Fig. Right side of machine
1. Steering pump
2. Rear axle
3. Engine suspension
4. Wheel nuts
1
2
3
4
Steering pump against engine (1) 38 Nm (28 lbf.ft).
Rear axle suspension (2) 330 Nm (243 lbf.ft), oiled.
Engine mounting (3). Check that all M12 bolts (x20)
are tightened, 78 Nm (57 lbf.ft).
Wheel nuts (4). Check that all nuts are tightened, 630
Nm oiled.
(The above applies to new or replaced components
only).
Diesel engine - Oil and Filter change
Observe care when draining hot engine oil. Wear
protective gloves and goggles. Observe care when draining hot engine oil. Wear
protective gloves and goggles.
Fig. Left side of engine
1. Drain plug
2. Oil filter
1
2
The oil drain plug (1) is most easily accessible from
the bottom of the engine and is located attached to a
hose on the rear axle.. Drain the oil when the engine is
warm. Place a receptacle that holds at least 10 liters
(2,7 gal) under the drain plug.
Replace the engine oil filter (2) at the same time. Refer
to the engine manual.
Hand in the drained oil to an environment-friendly
waste disposal station. Hand in the drained oil to an environment-friendly
waste disposal station.
89