Dynapac CA 152, Инструкция по эксплуатации

Страница: 61 / 119

Operation
ICA152-4EN3.pdf 2012-06-12
Braking
Emergency braking
37
39
Fig. Control panel
37. Emergency stop
39. Forward/Reverse lever
Braking is normally activated using the
forward/reverse lever. The hydrostatic transmission
retards and slows the roller when the lever is moved
towards the neutral position.
A disc brake in the drum motor and rear axle acts as
an emergency brake when in motion and as a parking
brake when stationary.
For emergency braking, press the emergency stop
(37), hold the steering wheel firmly and be
prepared for a sudden stop. The brakes are
applied and the engine stops. For emergency braking, press the emergency stop
(37), hold the steering wheel firmly and be
prepared for a sudden stop. The brakes are
applied and the engine stops.
After emergency braking, return the forward/reverse
lever to the neutral position and pull up the emergency
stop (37). The roller is fitted with an Interlock and
therefore the operator must sit in the seat to start the
engine.
Normal braking
38
39
42
Fig. Control panel
38. Vibration On/Off switch
39. Forward/Reverse lever
42. Parking brake knob
Press the switch (38) to switch off the vibration.
Move the forward/reverse lever (39) to the neutral
position to stop the roller.
Turn the engine speed control back to idling. Allow the
engine to idle for a few minutes to cool down.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature. When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
Activate the parking brake knob (42) even for short
stops on sloping ground. Activate the parking brake knob (42) even for short
stops on sloping ground.
51