Dynapac CA 152, Инструкция по эксплуатации

Страница: 95 / 119

Maintenance - 50h
ICA152-4EN3.pdf 2012-06-12
Tires - Air pressure - Wheel nuts - Tightening
Fig. Wheels
1. Air valve
2. Wheel nut
1
2
Check the tire pressures using a pressure gauge.
If the tires are filled with fluid, the air valve (1) must be
in the "12 o'clock" position during pumping.
Recommended pressure: See Technical
Specifications.
Check the tire pressure.
When changing the tires it is important that both
of them have the same rolling radius. This is
necessary to ensure proper functioning of the
anti-slip in the rear axle. When changing the tires it is important that both
of them have the same rolling radius. This is
necessary to ensure proper functioning of the
anti-slip in the rear axle.
Check the tightening torque of the wheel nuts (2) at
630 Nm (465 lbf.ft).
Check both wheels and all nuts. (This only applies to a
new machine or newly fitted wheels).
Check the safety manual that accompanies the
roller before filling the tires with air. Check the safety manual that accompanies the
roller before filling the tires with air.
Strike-off blade (Optional)
- Lubrication
Fig. Strike-off blade
1. Lubrication nipples
1
Always lower the blade to the ground before
leaving or parking the roller. Always lower the blade to the ground before
leaving or parking the roller.
Make sure that nobody is in the way when
operating the blade. Make sure that nobody is in the way when
operating the blade.
Wipe the nipples clean from grease and dirt, three on
each side of the machine.
Grease each nipple (1) with four strokes of the grease
gun. Ensure that grease penetrates the bearings.
85