Dynapac CA 152, Инструкция по эксплуатации

Страница: 59 / 119

Operation
ICA152-4EN3.pdf 2012-06-12
11 12
30
Fig. Instrument panel
11. Hydraulic oil temperature (Optional)
12. Engine temperature (Optional)
30. Warning lamp, air filter
Check while driving that the gauges show normal
readings. In the event of abnormal values or if the
buzzer sounds, immediately stop the roller and the
diesel engine. Check and remedy any fault; see also
the chapter on maintenance and the engine manual.
If the warning lamp for the air filter (30) comes on
during operation (when the diesel engine is
running at full speed), the main filter must be
cleaned or replaced. See the Maintenance
Manual. If the warning lamp for the air filter (30) comes on
during operation (when the diesel engine is
running at full speed), the main filter must be
cleaned or replaced. See the Maintenance
Manual.
Operating the strike-off blade (Optional)
1
Fig. Controls
1. Lever
Before driving, make certain that the blade is in its
uppermost position (raised). Inspect the condition
of the ground before using the blade. Before driving, make certain that the blade is in its
uppermost position (raised). Inspect the condition
of the ground before using the blade.
The lever (1) has three positions.
Backward - Raising the blade.
Forward - Lowering the blade.
Forward locked - Float mode, only its own weight
presses the blade down.
Lower the blade to the ground before leaving or
parking the roller.
1
2
3
Fig. Strike-off blade
1. Locking pin
2. Safety link
3. Parking catch
Use the blade only when driving FORWARD. Use the blade only when driving FORWARD.
When using the strike-off blade, the safety link (2)
must be secured with its locking pin in the parking
catch (3).
49