Dynamica HALO DB-20, Инструкция по эксплуатации

Страница: 63 / 120

.
r Y-axis upper limit in each Data Mode is as follows:
Low Scale (Lower Scale)
r Y-axis upper limit in each Data Mode is as follows:
Scan Speed (nm/min)
g speed.
ues are selectable:
200; 7)2400; 8)3600
Cycle Num (Cycle numbers)
e times which the sample is measured after the
Sequential,you can select Num Cycles from 1 to 99.
Cycle Time
alue from 0 to 9999 second.
Display Format
options –Sequential and Overlay -- in this function. If the
elected,
2. Sample Setup
ct sample setup from the Wavelength Sub Menu and a sub menu
Up Scale (Upper Scale)
Upper limit on Y-axis
The specifiable range fo
ABS:
Within a range of –3.000 to 3.000 in increments of 0.001.
%T: Within a range of 0 to 600.0in increments of 0.1.
Lower limit on Y-axis.
The specifiable range fo
ABS:
Within a range of –3.000 to 3.000 in increments of 0.001.
%T: Within a range of 0 to 600.0 in increments of 0. 1.
Wavelength scannin
The following eight speed val
1) 10; 2) 100; 3) 200; 4) 400; 5) 800;
6)1
This parameter indicates th
START key is pressed.
When Display Format is
When Display Format is Overlay, Num Cycle is fixed 2.
Input this v
There are two
Sequential is selected, only the last graph is displayed. If the Overlay is s
all the graph are displayed on the screen.
Press <2> to sele
list will appears on the right side of the screen as shown in the illustration below.
These parameters are the same as section 3.3.
3-22